Vin,
If you have had your Orion II sub-receiver in an AM mode while you
transmitted on SSB, you may have to reset your rig. There is a bug in the
Orion I software that was reported and fixed and then re-introduced in a
later release causing the headphone audio to be very low with the above mode
combination. I don't know if it also applies to CW and AM. I also don't
know if the Orion II has the same bug, but it is worth a try. I have the
Heil Pro headset and it works well as long as I don't have the sub-receiver
in the AM mode. Good luck.
73,
John
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of BobK8IA@aol.com
Sent: Tuesday, January 15, 2008 11:00 AM
To: tentec@contesting.com
Subject: Re: [TenTec] Heil headphones
In a message dated 1/15/2008 8:00:27 A.M. US Mountain Standard Time,
k1rm@sbcglobal.net writes:
Does anyone have a method that matches the output of the Orion 2 to the
Heil Pro set earphones. I believe the O2 has a 600 ohm output and the
headset is 8 ohms. I tried using two of radio shack 1000ohm to 8 ohm
audio transformers, but that didn't seem to work, unless I did something
wrong. I used two to try to use the stereo feature of the O2. I have
the rf mod in also.
I don't like unplugging the earphones and having the audio blast into
the room when I forget to turn down the audio gain.
Any help would be appreciated.
Vin, K1RM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|