On Tue, 2008-01-01 at 20:20 -0600, Bob McGraw - K4TAX wrote:
> How about this: GBPC3501 $2.92 in single lot qty. From Mouser
>
> Manufacturer data sheet: http://www.fairchildsemi.com/ds/GB/GBPC3501.pdf
>
> 35amp, 100 PRV. It is a real generic non-critical part. Now what's
> critical is to clean the bottom of the power supply where the bridge block
> mounts, make sure you have some good heat sink compound but not too much and
> bolt the sucker in tight with the center mounting screw. If you choose,
> use the crimp on spade lugs but do solder the wires to the female spade
> terminals. When pushing the lugs on, make sure they are tight and snug.
> Otherwise if you have a suitable soldering iron, solder the wires direct to
> the bridge block.
>
> 73
> Bob, K4TAX
>
Now he says it plugs into the PC board and the NTE lugs don't line up
with the slots in the board. In the NTE catalog I see two post
arrangements and one with round wires. I can't tell from here which
fits.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|