Re: [TenTec] 962 Power supply Bridge rectifier needed

["Bob McGraw - K4TAX" <RMcGraw@Blomand.net>]

How about this:   GBPC3501  $2.92 in single lot qty.  From Mouser

Manufacturer data sheet:  http://www.fairchildsemi.com/ds/GB/GBPC3501.pdf

35amp, 100 PRV.   It is a real generic non-critical part.  Now what's 
critical is to clean the bottom of the power supply where the bridge block 
mounts, make sure you have some good heat sink compound but not too much and 
bolt the sucker in tight with the center mounting screw.    If you choose, 
use the crimp on spade lugs but do solder the wires to the female spade 
terminals.  When pushing the lugs on, make sure they are tight and snug. 
Otherwise if you have a suitable soldering iron, solder the wires direct to 
the bridge block.
73
Bob, K4TAX


----- Original Message ----- 
From: "Lew " <ljl160@verizon.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, January 01, 2008 3:48 PM
Subject: Re: [TenTec] 962 Power supply Bridge rectifier needed


> Thanks again for the info. A few have said the part is available but no 
> one
> seems to know the brand or part number? If anyone remembers it would be
> great. Happy New Year again to everyone! Lew-KlNDV
>
> -------Original Message-------
>
> From: Bob McGraw - K4TAX
> Date: 12/31/2007 12:14:37 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] 962 Power supply Bridge rectifier needed
>
> Mouser has them.  {now if I could just find my Mouser catalog I'd give 
> your
> the part number}  Mouser.com and search.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message -----
> From: "Lew " <ljl160@verizon.net>
> To: <tentec@contesting.com>
> Sent: Monday, December 31, 2007 10:02 AM
> Subject: [TenTec] 962 Power supply Bridge rectifier needed
>
>
> > I need the 25 amp bridge replacement for a 962 ps. Ten Tec no longer has
> > the
> > exact replacement and a mod would be needed  as I was told. Not a big 
> > deal
> > but if I can find the exact sub, the unit can be put back the original
> > way.
> > If not, I will probably put in a heat sink and hard wire one in there.
> > Happy
> > New Year All! Lew K1NDV
> >
> > PS: I got alignment info for the Omni 6 Plus.
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> .
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec