Ken & Company:
I don't recall seeing anything of a dedicated alignment procedure outside of
the Omni VI Plus manual that I had. Same true for the Paragon and Paragon
II that I had. I do know that the procedure should be followed step by step
in the alignment and that the measurements must be made with adequate test
equipment of known accuracy for good results.
I commented to one reader that I've aligned several radios after their
owners attempted alignment unsuccessfully.
I no longer have the Paragon II or the Omni VI Plus manuals as they went to
the new radio owners when I sold them .
73
Bob, K4TAX
----- Original Message -----
From: "Ken Brown" <ken.d.brown@hawaiiantel.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, December 28, 2007 12:47 PM
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed
I understand Ten Tec had a 2 page alignment sheet for the Omni6 Plus. Does
anyone have a copy that could be e mailed or faxed to me?
I've never seen anything like that in any of the Ten-Tec manuals and
other papers I have for my Omni VI. I sure would like a copy too.
DE N6KB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|