>> By contrast, the Omni Six's open-frame amp relay is quite loud. There
are
>> other noiseless solutions for that, including the bypassing of the amp
relay
>> with a high-voltage, high-current MOSFET switch, capable of silently
>> switching nearly any AC or DC amp key line.
>As i happen to have an OMNI VI+, i would sure appreciate a point in the
>correct direction for a replacement to the noisy amp relay.
>Thank - you.
Tell us a bit more about the type of amp you're trying to interface and your
level of comfort with soldering/de-soldering a couple components inside the
rig. I can guide you through this, but you'll need to open the rig and make
a few minor changes -- all reversible if you later sell it.
Paul, W9AC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|