Remember too there was the PTT relay which had N.O. contacts for keying an
amp or other device. This relay could be turned on or off via the menu as
the CCO control as I recall. This relay was the source of most of the
clacking. The other relay, an enclosed reed relay shorted the RX line to
ground during transmit. It had a bit of a "ping" when it released.
73
Bob, K4TAX
----- Original Message -----
From: "Duane Calvin" <ac5aa1@gmail.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Sunday, December 09, 2007 6:19 PM
Subject: Re: [TenTec] OMNI VII QSK users with good ears....
The Omni VI/VI+ used a reed relay for T/R switching, even tho they may
have
used diodes in the circuit. Remember all the complaints about how some
folks could hear their relay and others couldn't? :-)
73, Duane
Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of ron
Sent: Sunday, December 09, 2007 5:53 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] OMNI VII QSK users with good ears....
On Dec 9, 2007, at 11:02 AM, Paul Christensen wrote:
>> I believe the Argo V DOES use diode switching. The
>> pin diodes used are exotic 1N4007.
>
> The Omni 6/6+ also uses a handful of 1N4007 diodes as part of the T/R
> circuit, particularly for the 2nd Rx port. However, isolation
> characteristics are not nearly as good as a true PIN diode
> structure.
Thanks Paul, I KNEW TT used diodes!
Me happy!
Ron, wb1hga
"relays?? what relays? ..."
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|