Don't try to remove the board if one of the diodes has failed (and it most
likely has).
Look and make mental note of the polarity direction, then reach in with
pliers and crush the diode. This leaves the two leads sticking up from the
board. Solder to them. Takes about ten minutes.
Phil k4dpk
----- Original Message -----
From: <k8bbm@srt.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, November 01, 2007 8:05 PM
Subject: Re: [TenTec] Sick 580 Delta
Look for a pair of diodes on ALC board, near power adjustment.
most likely one of them has failed - inexpensive
Dave
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|