Also, I would mention that the new Omni VII will also turns down to about 3
watts or so. No mods required.
Since both the Omni VI Plus and the Omni VII have separate RX inputs, I use
a 20 dB attenuator between the output of the radio and the input of the
transverter. This allows the radio to operate at about 15 watts and gets
about 150 mW into the transverter. Also, should I forget and wack it with
full power, the transverter doesn't get fried. My 20 dB attenuator is a PI
configuration using a 50 ohm 25 watt load for the input R, a 51 ohm 1/2 watt
R for the output value and a 200 ohm 1/2 watts R for the series element
between the input and output. Now these values don't make for an exact 50
ohm input but neither the radio nor the transverter seem to care. The loss
is about 20 dB which is all that counts. I use a separate RX line from the
transverter to the AUX RX input.
Also should note that my transverters are DownEast Microwave units that only
require about 100 mW to 150 mW of drive for full output.
73
Bob, K4TAX
----- Original Message -----
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, October 05, 2007 11:03 PM
Subject: Re: [TenTec] Omni VI question
My Omni VI Plus just turned down to 5 watts using the RF Level control.
73
Bob, K4TAX
----- Original Message -----
From: <K5XS@aol.com>
To: <tentec@contesting.com>
Sent: Friday, October 05, 2007 10:25 AM
Subject: Re: [TenTec] Omni VI question
Steve,
I seem to recall (traded my Omni VI+ for an Orion II this year) and my
log-book records working with as little as three watts just cranking
down
the
"Power" control (ganged with the "Mic" microphone gain knob, bottom
left). I
did no mods to the radio; it came that way from the factory.
73,
Bernie K5XS
In a message dated 10/5/2007 10:15:05 A.M. Central Daylight Time,
wa9jml@tbc.net writes:
Is there a way to reduce the TX power output of the Omni VI or VI+ to 5
watts?
My Omni V has this mod done to it, and I am thinking of getting another
radio
to act as the IF for my Elecraft transverters. Right now, I am using my
Argonaut II but would like to free that up for portable and QRP
operating.
TNX,
Steve WA9JML
************************************** See what's new at
http://www.aol.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|