TenTec
[Top] [All Lists]

Re: [TenTec] Inrad Roofing Filters for Omni VI

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Inrad Roofing Filters for Omni VI
From: Bill Cotter <n4alg@qx.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 14 Jun 2007 19:22:32 -0400
List-post: <mailto:tentec@contesting.com>
Paul,

I have installed the two 400Hz Inrad filters (#750/#759), in addition to the 600Hz roofing filter (#763) and board. I can tell you from my perspective, after replacing the TT 2x500 and 2x250 filters, that the choice was worth the expense. My primary usage is CW DX'ing for the weak ones, in crowded and noisy conditions.

The 400Hz filters are razor sharp, very low ringing, and seem to enhance the signal by diminishing the noise power in the passband. I seldom the TT NR-DSP because of the distracting artifacts, but it REALLY is more useful with the Inrad filters - I think due to less noise to process. And, as Clark mentioned, when you switch in the roofing filter, the adjacent QRM disappears.

The TT 250Hz filters drove me crazy with the hollow-ringing and constant 'chasing' a weak signal around the passband. The 500Hz TT filters were just the right width, but the shape factor always seemed too large. I never had extra TT filters to swap around to discover if there was anything unusual about the pairs I owned.

After using the Inrad 400Hz filters, I bit the bullet and purchased one of the #766 1,000Hz filters for the N2 position. I wanted a 'wide' window for sleuthing around the band, and it is an absolute delight. I just wish that Inrad would produce the compliment 6.3mHz 1,000Hz filter. I have been advised that if they receive enough orders, they will market one. For now, I continue to use the 1.8kHz TT filter.

73 Bill N4LG


At 11:52 AM 6/14/2007, you wrote:
I only see a couple of entries in the eHam reviews for the Inrad roofing filters for the Omni VI. I'm considering getting the CW version and would appreciate any comments on the performance enhancement that these filters provide.

Thanks,

Paul, K5AF



************************************** See what's free at http://www.aol.com.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


----------------------------------------------------------
Bill Cotter, N4LG             E-mail: n4alg@qx.net
173 Carolyn Lane               Home: (859) 887-5563
Nicholasville, KY 40356-9340   Work: (859) 323-6474

ARRL   ARCI #9878   QRPl #1646   QCWA #29393   FISTS #4535
----------------------------------------------------------

<Prev in Thread] Current Thread [Next in Thread>