There are some early revision notes on the download website, but the full
scoop is in a .doc file in the download called Orion History.doc. Here is
the section on the newest updates since 2.037j:
Version 2.038i
Changed Voice Record system. Monitor now OFF during record unless the user
has MON turned on.
Added recall of preset antenna selection to the serial frequency set
routine.
Modified AGC for AM RX because it was causing distortion.
Added on-screen SPLIT annunciator.
Added on-screen BAND REGISTER indicator (A,B,C,D)
Modified TGC for AM transmit to correct carrier level control.
Added FM mic limiter to prevent over-deviation.
Increased BW limit to 9khz for improved am rx
Added ULcc<cr> code to the serial command structure to control the line-out
selection and level.
Added UL? Query to the serial command set,
Fixed the sub S-Meter display and SQL operation that caused meter to
disappear.
Scaled FM and AM audio levels to get more output on speaker and rear panel
outputs.
Version 2.038j
Corrected bug that caused VOX to turn off on a band change.
Version 2.038k
Correct bug that caused band register 'A' to be overwritten when any band
change was made.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "George" <goofyham@highstream.net>
To: "Brad Johnson" <aa5ch@suddenlink.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Friday, April 27, 2007 4:53 AM
Subject: Re: [TenTec] New OII Firmware
Where are the firmware revision notes for 2.038K?
Thanks.
George
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|