Mike,
I echo Steve's results. I have driven both an Acom 2000A and a QRO HF2500
with my Orion II and my Orion, and both deliver full output at very low
drive. Both run 4CX800 tubes which are very high gain bottles.
How much output are you getting from the Orion? If you're not getting 1500
watts plus with less than 50 watts drive, there is a problem somewhere. You
should be able to drive the pants off your 8100.
Have you checked the amp output into a dummy load?
Larry, W0PR
----- Original Message -----
From: "STEVEN KLINE" <skline4@verizon.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Sunday, April 08, 2007 11:05 AM
Subject: Re: [TenTec] AMP driveOrion II versus Icom Pro II
Michael,
Run an ORION with version 1.372 software with Alpha 8100. Twenty three
watts from ORION gives me slightly over 1KW. Thirty to Forty watts
drive from ORION puts me at or ABOVE legal limit. Don't use a tuner
with the F12 mono banders, either.
Steve - W5JK
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Michael W Elliott
Sent: Thursday, April 05, 2007 8:57 PM
To: tentec@contesting.com
Subject: [TenTec] AMP driveOrion II versus Icom Pro II
.... SNIP ...
I can consistently get 1500 out driving the Alpha 99.
Orion I do not get 1500.
Anyone else seen this ?? Is there a setting I am
missing with the Orion..
Please contact me offline if you have some
suggestions.
de
KQ0B
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|