Bill,
There's waaaaay too many parameters here to try to do it via email.
Give me a call, 952 212 2664, and we can do it on the phone. I have an
MK2R+ and it works marvelously. My office is here at my home, so I'm home
most of the time, and I'll bein the shack after 2300z.
Larry, N0XB
----- Original Message -----
From: "Bill Gaines AD8P" <ad8p@wcoil.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, February 11, 2007 11:20 AM
Subject: [TenTec] Micro Keyer and Keying an Orion
I bought a Micro Keyer last week to interface with my Orion. Well let me be
the first to say I am a total geek when it comes to computers and if it
isn't specifically spelled out for me in the instructions then I am going
to have issues. Well I have issues. I am certain that some of my esteemed
colleagues in radioville use the Micro Keyer and the Orion. Please let me
know how to contact you so I can copy your settings in the rig and in the
router so I can get it up and running.
In setting up the router I can get it to sent "test" when I hit the test
button on the WinKey comport. I can also get it to key the rig from the CW
key port and the software also follows the rig on the control port. It
also sends tones from the FSK test button in router. However, I can't seem
to get any setting to work with N1MM logger. It will track in N1MM but it
won't key the rig.
I was able to get MMTTY to run but I could be transmitting "upside-down"
as no-one would respond to me last night and I am sure it isn't signal
strength. I was able to make it generate tones however and key the rig but
as a standalone program....not in N1MM Logger.
Come on guys.....any help is appreciated. This list has always come
through for me. I searched the archives and found nothing there by using
Micro Keyer Orion as my search criteria.
Bill AD8P
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|