Re: [TenTec] USB Serial Converters

["dsteele" <dsteele@iowatelecom.net>]

Carl, Will this convertor key FSK from MMTTY?

Don Steele
NT0F

----- Original Message ----- 
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, February 03, 2007 3:18 PM
Subject: Re: [TenTec] USB Serial Converters


> Yes, you sure can.  These devices give you simultaneous multiple comports
> that do not interfere with each other.  There are a lot of them out there
> that have very poor driver software that will fail under heavy use at the
> higher baud rates used by Orion's, Pegasus's, and Jupiter's.  The only
> reason I recommended Keyspan is I know the driver software for Keyspan is
> very good.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message ----- 
> From: "Mark Choate" <aa0yy@sbcglobal.net>
> To: "Carl Moreschi" <n4py@arrl.net>; "Discussion of Ten-Tec Equipment"
> <tentec@contesting.com>
> Sent: Saturday, February 03, 2007 4:05 PM
> Subject: Re: [TenTec] USB Serial Converters
>
>
> > Hello Carl, and by the way, I love the new features of my Omni V.92 chip,
> >
> > question on these usb serial  thing-a-ma-jiggies. Can I leave ... I
> guess...
> > up to 4 rig/devices hooked to one USB port, and control them all
> > simultaniously? For example, First rig on some soundcard interface unit
> > running psk/rtty/etc with say "hamscope" or some other program, then a 
> > 2nd
> > rig on rig control off my logging program that I would use for catching 
> > DX
> > spots off the cluster, and both be functioning?  all on the same PC? Me
> just
> > clicking the mouse?
> >
> > I know its kind of a big question but I have been using an old multiplex
> > manual switch that I got for 10 bucks from Buxcomm, but I have to choose
> > ahead of time which rig/device I am going to use and I cant always just
> > switch back and forth without something locking up.
> >
> > I know I kind of directed this question at you Carl but anyone with info
> pse
> > respond. dont mean to be so ignorant on the topic but before I fork out
> > $100-150 for this switch/device I would rather look like a sheeny-bone
> here.
> > Thanks, Mark
> > aa0yy
> >
> >
> > ----- Original Message ----- 
> > From: "Carl Moreschi" <n4py@arrl.net>
> > To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> > Sent: Saturday, February 03, 2007 11:58 AM
> > Subject: Re: [TenTec] USB Serial Converters
> >
> >
> > > Rick,
> > >
> > > I recommend the 4 port from Keyspan at www.keyspan.com model USA-49WLC.
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec