| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] UCW and LCW |
| From: | "John B. Egger" <john_egger@comcast.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 28 Oct 2006 00:47:43 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
I'm a bit puzzled by these two O-2 modes. When UCW is selected, the
lower CW sideband is audible; that is, if zero-beat is 7020, to hear the
signal one tunes down to 7019 etc. When LCW is chosen, one must tune UP
from zero-beat to hear the signal.
Isn't this the opposite of what LCW and UCW should mean? -- --John K3GHH Registered Linux User #291592 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] RF gets into computer, jsb |
|---|---|
| Next by Date: | Re: [TenTec] UCW and LCW, Grant Youngman |
| Previous by Thread: | Re: [TenTec] RF gets into computer, jsb |
| Next by Thread: | Re: [TenTec] UCW and LCW, Grant Youngman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |