In a message dated 9/26/2006 4:34:03 P.M. Pacific Standard Time,
tentec-request@contesting.com writes:
I can not get the Steppir (4.591) controller to interface with the Orion II
(2.037j).
Transceiver mode on the steppir is ORION.
I am using Baud 57600. I am plugged directly into the Orion ( no Y cable).
Anyone who has this working please send me an email.
Steppir says they only read from the radio, so it is not something they can
fix.
Ken K5WK
I don't think the steppir reads the orion, I had to use the y cable and run
either my logger ( AC LOG) or ham radio deluxe. HRD reads the orion and the
steppir poles the HRD to pick the freq.
my original set up did not work but I up graded to steppir controller ver
6604 and it started working fine.
good luck, it works with my orion original.
tom N6AJR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|