While the version could very well be the problem, I would look at the keying
voltage and current to be sure it's within the Orion's specifications. IIRC
without looking at the schematic, it uses a 2N3904 to pull down amp keying,
which limits the dissipation. I have had no trouble keying my older TT
Titan (425), and although the voltage is higher than spec, I measured the
current at only 4 ma.
Ron N6AHA
----- Original Message -----
From: <K4IA@aol.com>
To: <tentec@contesting.com>
Sent: Monday, August 28, 2006 2:27 PM
Subject: Re: [TenTec] Orion no Tx, no main Rx
In a message dated 8/28/2006 5:03:02 P.M. Eastern Daylight Time,
aa6e@ewing.homedns.org writes:
is that the Orion (1.373b5)
There's your problem. As I recall that version had an issue with
lockups.
Maybe others will comment but I would say try a newer version of the
software
or go back to 1.371 - the last of the stable V1.X where the noise
reduction
actually made a difference.
k4ia
Craig "Buck"
Fredericksburg, Virginia USA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|