57600 baud
8 bit
no parity
1 stop bit
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Eugene Klingler" <n8zx@hughes.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, July 12, 2006 1:02 PM
Subject: [TenTec] dxbase 2006/orion II
> anyone know the baud rate, word length, parity & stop bits to use for the
orion II to be controlled by dxbase 2006....thanks gene klingler n8zx
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|