It's pretty clear from the graphs that there is 2 different filter centering
algorithms going on. The main receiver is using the normal scheme where in
SSB the bottom of the filter is set at 200 hertz and the top ends up at 200
+ the filter BW.
The sub-receiver is just putting the center of each filter at 1500 hertz.
So to make them sound the same, you would have to use PBT to move the
sub-receiver lower end passband to 200 hertz. This would be a variable
amount depending on the filter selected.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Lin Davis" <linbdavis@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, March 16, 2006 10:09 PM
Subject: Re: [TenTec] Roof filters (N4PY and KC9CDT)
> Nice job Grant!
>
> Grant Youngman wrote:
>
> >>Have you e-mailed DitsnBits about this SUB RX bandpass issue.
> >>Or has anyone else??
> >
> >
> > Yes, I have. I'm going to send them another note, with this file
attached.
> >
> > http://tinyurl.com/n82l2
> >
> > It's hard to miss the fact that something is amiss :-)
> >
> > Grant
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|