This happened to me also. Radio was in the receive mode but the centurion
amp was indicating that it was transmitting as the transmit light was on and
I was seeing plate current. I have reloaded the 2.31 software and the
problem has left for now. Gene WB9HLA
----- Original Message -----
From: "Ron Castro" <ronc@sonic.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, March 03, 2006 4:49 PM
Subject: Re: [TenTec] 2.031 QSK bug - this is not a bug
> The Ten Tec keying loop in the 425 is probably different than the
> Ameritron.
> It is possible to hear with the linear in transmit, and in fact I did,
> just
> not very well. There is enough inter-electrode capacitance in the
> 3CX800's
> to pass some signal back from the antenna to the input. Sort of an
> attenuator with 2,400 VDC on it!
>
> Ron Castro
> Chief Technical Officer
> Results Radio, LLC
>
>
> ----- Original Message -----
> From: "Grant Youngman" <nq5t@comcast.net>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> Sent: Friday, March 03, 2006 11:30 AM
> Subject: Re: [TenTec] 2.031 QSK bug - this is not a bug
>
>
>>> Ron - if the QSK loop is open, the rig does not transmit.
>>
>> His problem was that 2.031 seemed to "stick" with TX OUT pulled low
>> keying
>> his amp even though the radio was in receive mode ?? (Is that even
>> possible?)
>>
>> I've been playing with mine using the loop on an AL-1200 on and off all
>> morning, seeing if I could duplicate it, but it's working without a
>> hitch.
>>
>> Grant/NQ5T
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|