Re: [TenTec] Distorted and "clicky" receive audio; Orion

["Grant Youngman" <nq5t@comcast.net>]

> master reset, and the distortion problem went away; the 
> "clicks" remained when rotating the BW and multi switch with RX EQ.

Ten-tec answered this question somewhere along the line.  It is caused by
the method of dynamically computing rather than pulling up pre-stored filter
parameters.  The mix of old filter and new filter parameters as they are
being updated manifests as a click in the audio.  The response was
specifically addressing the slight click that occurs on BW change.  Perhaps
EQ is done the same way.

It's normal.  

Grant/NQ5T


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec