I have seen this in CW when the automatic notch is on.
It is operated independantly from sub to main which
is why you did not hear this in the sub.
73,
John NA9U
--- Lou Laderman <lladerman@earthlink.net> wrote:
> I installed v2.055 yesterday. Operating ssb this
> afternoon, after a time
> received signals in the main receiver became
> distorted (sounded like
> they were clipping) and had discernable "clicks."
> In addition, changing
> the bandwidth or the RX EQ setting caused
> discernable clicks in the
> audio. This occurred with either noise blanker on or
> off. Checking on
> cw, the signals sounded almost like pulse signals,
> hardly any carrier at
> all. The sub receiver was fine. I performed a master
> reset, and the
> distortion problem went away; the "clicks" remained
> when rotating the BW
> and multi switch with RX EQ.
>
> Has anyone experienced this?
>
> Lou, W0FK
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|