----- Original Message -----
From: <caseke@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, February 14, 2006 11:45 AM
Subject: [TenTec] Orion II RTTY Problem (Fixed)
Thanks to all of you who wrote in response to my note. I neglected to
mention that I am using Writelog, although that does not figure into the
solution to the problem.
Paul Clinton at TenTec and I talked this morning and he walked me through
a number of things, one of which worked. It is pretty simple - when in
LSB mode , set the PBT to -1960 (that's MINUS 1960). That one thing made
the difference. Perhaps I should have been smart enough to try that
without prompting, but since the original Orion specified LSB and +1960,
and that worked well, it never occurred to me to try -1960.
One other thing - I finally got a look at the Orion video in which Scott
walks us through the use of the Orion. In particular, the part about
programmable AGC and the three adjustable settings was MOST helpful, far
more useful than just accepting one of the several suggested DX settings
that are floating around. I am firmly convinced that knowing just a bit
more about setting the AGC has been instrumental in succeeding with a few
Q's that would not have happend otherwise.
I lied - one more thing yet. The O II is a real pleasure to use and I'm
thrilled to have it. Like somebody else mentioned, either conditions have
been great, or I am hearing better than I did before with the original
Orion.
73, Ken K5KC
***********************
My Orion II arrived last Friday. It is working superbly EXCEPT for a RTTY
problem.
I am using AFSK via a sound card (same setup as for my Orion - and that
still works fine on RTTY).
The problem with the OII is that when I run it on LSB and PBT at 1960 per
the TenTec instructions, I am not able to get the signal to decode, even
though I can hear RTTY signals through the speaker or headphones. The
tuning window, a pair of orbit-shaped ovals, will not open up for tuning.
HOWEVER, when I go to USB and PB 1960, and also to REVERSE MODE on my RTTY
software, all works well and I can make QSOs, except everything is
backwards.
Here are some things I tried, with no change in the problem:
1. Taking audio from the headphones rather than from the audio out on I/O
plug in back.
2. Reloading the current update.
3. Loading the previous update.
4. Pulling the skins and checking quite carefully for connection
problems.
Just to be sure I hadn't goofed something up, I fired up the Orion (I) in
place of the Orion II and it still works fine using the same setup, so it
is something to do with the Orion II.
Has anybody had this problem? Is anyone having success on LSB using AFSK
RTTY? Suggestions?
73, Ken Case K5KC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|