Charlie;
My Orion had no sub receiver receive. Only funny sounds that were not
changed when I tuned the sub VFO up and down in frequency.
I'll try my best to tell you how I removed and replaced the SAME battery.
There is no need to actual put a new battery in if the original one is OK
and it probably is.
Take the top off. You'll need a funny hex screw tip screw-driver of sorts to
take those funny screws off in the back.
Take the top off then take the bottom off. On the bottom you'll see a small
round battery. Remove it and wait for a minute then put the SAME battery
back in.
This erases the RAM memory that Ten Tec said a RAM clear does but I tried a
RAM clear on mine and that didn't solve the problem. The removal of the
battery and putting the SAME battery back in fixed the problem in mine. Not
saying yours will act the same way but it's worth a Ham try!
George
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|