George,
Thanks for the tip. I will try it in the morning. Do you remember what
problems your Orion was exhibiting when you removed and replaced the
battery.
Charlie
----- Original Message -----
From: "George K" <w2yj@highstream.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, January 22, 2006 11:55 AM
Subject: [TenTec] ORION_NO_REC_ON_SUB_CHARLIE
> Charlie;
> If you are up to it try taking the bottom case off and remove the little
> watch type battery for about a minute and then replacing it. Check the
> voltage of the battery as well. I don't know the voltage but it should be
> printed on the case.
> I was told by Ten Tec that doing a RAM clear should do the same thing,
> BUT,
> being a ham, I had to try everything before sending it in.
> I did this after all else failed and WOW, my Orion was back in business.
> It saved me the cost of shipping and the wait.
>
> George
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|