If you haven't tried it, do a reset holding the VFO B LCK key. This clears
RAM memory, and solves a myriad of ills that can be caused by corrupted
RAM-stored variables. I had to do this with my II when it arrived to get CW
mode to work on the SUB receiver.
You'll get a Battery Fail message, and then the usual reset queries. Clear
everything.
Grant/NQ5T
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of Don and
> Diana Cunningham
> Sent: Thursday, December 22, 2005 10:20 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] Orion
>
> Toby, Carl and all, I re-tried the User 2/power on reset
> again, and thought it was going to do it. Turned the lights
> off, and a "garbled" screen came on with the "system loading"
> sign, then locked up. Subsequent tries, over a period do
> nothing, so with your help, I am afraid I am finding that it
> gets to take a trip to Tennessee after Christmas. Thanks to
> all of you for helping me. On the bright side, they can
> check that the CPU/DSP board has in fact been already modded
> for version 2 scan like sales assured me that the demo units
> had been done while there!! At least have a good Omni V to
> keep me going, hi.
> 73 all,
> Don, WB5HAK
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|