Hi Paul,
Those are the typical symptoms of a defective optical encoder. Call
Ten-Tec and they can fix you right up.
73,
Pat-K4BEH
On Fri, 2 Dec 2005 10:07:14 -0600 "Paul DeWitte K9OT" <k9ot@mhtc.net>
writes:
> My Omni VI + has an intermittent problem with the VFO. Sometimes it
> will not
> change the freq at all when turning the VFO and sometimes it works
> in just
> one direction and will not work going the other way. It may work
> very
> erratic in either direction, and after while it may start to work OK
> in both
> directions.
>
> I have tried reset and that did not seem to make any difference.
>
> Not sure I have explained this so it makes any sense. Has anyone had
> this
> problem with theirs?
>
> I was hoping to use it in the 160M contest but if I cant change freq
> it wont
> do me much good.
>
> Thanks 73 Paul K9OT
>
>
>
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.1.362 / Virus Database: 267.13.10/190 - Release Date:
> 12/1/05
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|