Hello Paul and the list --
I had the very same problem some years ago with my VI+. It was a bad
incoder. To check this, on the circuit board behind the tuning knob
interchange the two wires going to the RIT incoder with the two wires
going to the MAIN incoder. I think the numbers were 55 & 56 on one
incoder. My memory fails me. Check the drawings or call TT. If the VI+
now tunes correctly with the RIT incoder, then the MAIN incoder is
provevn bad. Call TT for a replacement.
Good luck!
73,
Ariel, k4aal
Paul DeWitte K9OT wrote:
My Omni VI + has an intermittent problem with the VFO. Sometimes it will not
change the freq at all when turning the VFO and sometimes it works in just
one direction and will not work going the other way. It may work very
erratic in either direction, and after while it may start to work OK in both
directions.
I have tried reset and that did not seem to make any difference.
Not sure I have explained this so it makes any sense. Has anyone had this
problem with theirs?
I was hoping to use it in the 160M contest but if I cant change freq it wont
do me much good.
Thanks 73 Paul K9OT
|