Lee,
Unfortunately my knob isn't the configuration you describe below in that the
skirt doesn't turn. It's anchored (or molded at three points) to the inside
surface of the knob and is held on to the 1/4 inch shaft by one set screw.
It's possible I don't have the latest version of the knob assembly on this
unit which I purchased as reconditioned equipment from TT recently.
It was worth a try. Still a good radio.
Charles, K0CW
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of B. Lee Cornwell
Sent: Sunday, October 30, 2005 6:54 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Paragon
Hello Charles - Slide the rubber part of the tuning knob off - This
exposes 2 set screws that must be removed with an allen wrench - remove
the knob and look at the back - It becomes self-explanatory - Basically
you hold the skirt of the knob while turning the main knob - this
changes the drag placed against the panel - a quick shot of "tri-flow"
may be needed on the encoder shaft
73
Lee K2BLC
Charles Nagel wrote:
>Is there a way to do it? Please advise me on-list.
>
>Thanks,
>
>Charles, K0CW
>
>-----Original Message-----
>From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
>On Behalf Of Jim G
>Sent: Saturday, October 29, 2005 10:57 PM
>To: Discussion of Ten-Tec Equipment
>Subject: [TenTec] Paragon
>
>Need some help on how to decrease the tension on the tuning dial. Please
>reply off-list to longpond@downeast.net. Jim K1QCF
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
--
B. Lee Cornwell
http://home.earthlink.net/~k2blc/index.html
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|