Hello Charles - Slide the rubber part of the tuning knob off - This
exposes 2 set screws that must be removed with an allen wrench - remove
the knob and look at the back - It becomes self-explanatory - Basically
you hold the skirt of the knob while turning the main knob - this
changes the drag placed against the panel - a quick shot of "tri-flow"
may be needed on the encoder shaft
73
Lee K2BLC
Charles Nagel wrote:
>Is there a way to do it? Please advise me on-list.
>
>Thanks,
>
>Charles, K0CW
>
>-----Original Message-----
>From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
>On Behalf Of Jim G
>Sent: Saturday, October 29, 2005 10:57 PM
>To: Discussion of Ten-Tec Equipment
>Subject: [TenTec] Paragon
>
>Need some help on how to decrease the tension on the tuning dial. Please
>reply off-list to longpond@downeast.net. Jim K1QCF
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
--
B. Lee Cornwell
http://home.earthlink.net/~k2blc/index.html
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|