Re: [TenTec] SSB recieve audio?

["Steve N4LQ" <n4lq@iglou.com>]

Barry you lost me there. Alignment of what?

Steve Ellington
N4LQ@iglou.com
----- Original Message ----- 
From: "Barry Gross" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, May 29, 2005 10:43 AM
Subject: Re: [TenTec] SSB recieve audio?


> On 5/29/05, Steve N4LQ <n4lq@iglou.com> wrote:
>> I did some measurements on the Omni VI. Nothing below 300hz get's past 
>> the
>> detector. The notch and DSP are not to blame. It has to do with the 
>> position
>> of the BFO within the IF passband.
>
> The lower cutoff of the audio passband (after the detector) is easily
> adjusted by alignment.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec