Sorry Folks:
I've been out of town and away from the computer and radio for a few days.
I'll look into some suggestions I've received and then decide just how to
proceed. Thanks for the offers and suggestions. I hang on to your e-mails
and info.
Thanks again.
73
Bob, K4TAX
----- Original Message -----
From: "Ken Simpson W8EK" <W8EK@speakeasy.net>
To: <RMcGraw@Blomand.net>
Cc: <W8EK@speakeasy.net>
Sent: Saturday, May 21, 2005 8:40 AM
Subject: RE: Omni Manual
>
> I did not get any answer to this.
>
> Maybe it got lost.
>
> Thanks.
>
> 73,
>
> Ken, W8EK
>
>
>> -----Original Message-----
>> From: Ken Simpson, W8EK [mailto:W8EK@speakeasy.net]
>> Sent: Friday, May 20, 2005 8:13 AM
>> To: 'RMcGraw@Blomand.net'
>> Subject: Omni Manual
>>
>>
>> Hi Bob,
>>
>> Which series Omni is it (A, B, or C)? I probably have a
>> manual, depending on the series.
>>
>> Thanks.
>>
>> 73,
>>
>> Ken, W8EK
>>
>> Ken Simpson
>> E-mail to W8EK@speakeasy.net or W8EK@arrl.net
>> Voice Phone (352) 732-8400
>>
>>
>>
>>
>> > -----Original Message-----
>> > From: tentec-bounces@contesting.com
>> > [mailto:tentec-bounces@contesting.com] On Behalf Of Robert &
>> > Linda McGraw K4TAX
>> > Sent: Thursday, May 19, 2005 9:03 PM
>> > To: tentec@contesting.com
>> > Subject: [TenTec] Omni D Schematic/Manual
>> >
>> >
>> > Acquired a Omni D that has a low power output (35 - 45 watts)
>> > problem on all bands into 50 ohm load. I need a schematic or
>> > manual and suggestions. Power supply is running 13.5 V at
>> > the radio under load. Draws about 8 amps under tune (LOCK)
>> condition.
>> >
>> > Thanks in advance
>> >
>> > 73
>> > Bob, K4TAX
>> > _______________________________________________
>> > TenTec mailing list
>> > TenTec@contesting.com
>> > http://lists.contesting.com/mailman/listinfo/tentec
>> >
>>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|