I have the Omni D book and can photocopy if needed. K3TX
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Donald
Sent: Thursday, May 19, 2005 9:25 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni D Schematic/Manual
Turn the ALC control completely clockwise and leave it there always.
Does that help?
Don, W4DON
----- Original Message -----
From: Robert & Linda McGraw K4TAX
To: tentec@contesting.com
Sent: Thursday, May 19, 2005 9:02 PM
Subject: [TenTec] Omni D Schematic/Manual
Acquired a Omni D that has a low power output (35 - 45 watts) problem on
all bands into 50 ohm load. I need a schematic or manual and
suggestions. Power supply is running 13.5 V at the radio under load.
Draws about 8 amps under tune (LOCK) condition.
Thanks in advance
73
Bob, K4TAX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|