Don't get hung up on connector type etc.
For a 3 wre hookup, you need ground to ground, XDon one end to Rdata onthe
other end.
Look at the diagram on p5-9 fig 5-10B.
----- Original Message -----
From: "Andy Bullington" <abullington@comcast.net>
To: <tentec@contesting.com>
Sent: Saturday, May 21, 2005 00:15
Subject: [TenTec] Omni V.9 DB25 to DB9
> Thanks to all who have answered. I HAVE the manual. The wiring diagram is
> for DB25 to DB25 for PCs.
> The diagram for DB25 to DB9 is for Macs. Will it work for PCs too? All I'm
> trying to do is wire up a simple 3 or 4 wire
> DB9 to DB9 for my Omni V with the N4PY chip. You absolutely CANNOT use any
> standard cables for computer connection.
> you have to make one up. I used to have the proper diagram but I've lost
> it. I don't HAVE a spare DB25 connection on
> my newer PC , otherwise I would just use the diagram in the manual. I
could
> wire up DB25 to DB25 and use an adapter I guess, but I'd rather just do it
> right in the first place. I was hoping someone simply knew the pin
> assignments on the DB9 side. Thanks.
> Andy W1AWB
> >>you can also use a DB25 to DB9 adapter for that if you have one handy. i
> have used such an adapter many times. jack ak7o
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|