Hi Gary,
I've been reminded to that TenTec still supplies them as you knew. For
some reason that didn't enter my mind.
If you have the pins to go with it, that would be great. If not, don't
worry about sending and I can contact TenTec.
My address is
Pete Meier
4181 Rural St.
Waterford, MI 48329
Regardless, thank for your generosity.
Pete WK8S
On Apr 5, 2005, at 9:55 PM, Gary Miller wrote:
I have an extra 4 pin Molex plug I just got from Ten Tec but can't use
(had to buy an even older 6-pin Cinch Jones).
Send me your address and I'll mail it to you.
Gary N2CVZ
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Pete Meier
Sent: Tuesday, April 05, 2005 9:28 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Power connector for older TenTec rigs and/or hand
mike??
Where can I obtain a power connector for an older TenTec rig to a
non-TecTec power supply?
I think they use a Molex connector which is easy to construct but don't
know the part designation.
I'd consider a previously owned already built cable if some has an
extra.
I'm also looking for a hand mike (model 700?) also.
Pete WK8S
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|