Every Ten Tec I have ever owned I have pulled the real panel mount power
socket and installed my own.
See if you have enough room at the top or bottom of the power connector to
snake thru a no. 12 or so B+ line and solder it on top of the originial B+
line. Chassis is common to ground.
----- Original Message -----
From: "Pete Meier" <pmeier@mac.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, April 05, 2005 6:28 PM
Subject: [TenTec] Power connector for older TenTec rigs and/or hand mike??
Where can I obtain a power connector for an older TenTec rig to a
non-TecTec power supply?
I think they use a Molex connector which is easy to construct but don't
know the part designation.
I'd consider a previously owned already built cable if some has an
extra.
I'm also looking for a hand mike (model 700?) also.
Pete WK8S
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|