> ....Some
> other's have told me that with non-Ten Tec amps, the problem
> does not exist. The whole thing is just strange.
I agree, especially given the proposed solution.
I haven't experienced a problem losing transmit with my AL-1200 (internal
QSK board). And I run with only loop #1 turned on.
Of course, I still occasionally forget to turn on the loop when turning on
the amp and BEFORE hitting the key or footswitch, and proceed to burn out
the receive-side PIN diode protective fuses in the amp occasionally .. But
that's a "aw sh*t" issue rather than a real one. If there just weren't so
many screws to get the AL-1200 case off :-)
Grant/NQ5T
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|