Re: [TenTec] Orion Mic Woe's

["Toby Pennington" <toby423@earthlink.net>]

Yep,  Just fold the shield braid back over the insulation and secure the 
clamps down tight over the shield braid to make a secure mechanical 
conntection, cut away any excess that sticks out of the connector.  Connect 
the other end of the ground braid to the mike shell.

Toby W4CAK


----- Original Message ----- 
From: "NJ0IP" <Rick@DJ0IP.de>
To: <tentec@contesting.com>
Sent: Saturday, December 11, 2004 11:10 AM
Subject: [TenTec] Orion Mic Woe's


> Gentlemen, forget the "theory" and focus on practice.
>
>
>
> I have just disassembled my 30 year old Shure 444 and as I suspected, it 
> has
> both grounds tied together to pin 2.
>
> To be exact, pin 2 has the cable shield attached and the "mic-" and "PTT
> Gnd"  are both tied to this.
>
> There is yet another unused wire in the cable which I could use for the 
> mic-
> but I still face one more problem:
>
> How on earth do you make a good electrical and mechanical connection to 
> the
> 4-pole plug's case?
>
> This has not been provisioned for.
>
> I thought maybe my old plug was outdated, so I inspected the new plug that
> shipped with my Orion and it is exactly the same.
>
> The only way I see to do this is to run the shield back along the outside 
> of
> the cable and secure with the strain release.
>
>
>
> Anyone else been there and done?
>
> How?
>
>
>
> 73
>
> Rick
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec