[TenTec] Re: TenTec Digest, Vol 20, Issue 59

[Eric Rosenberg <wd3q@starpower.net>]

Tom --

I (still) haven't opened up the box.

How would you modify the filter cover, and have you spoken to INRAD 
about this?

Eric W3DQ


At 01:49 PM 8/14/2004 -0400, you wrote:
> From: "Tommy" <aldermant@alltel.net>
> Subject: Re: [TenTec] Inrad 762
> Date: Sat, 14 Aug 2004 13:15:56 -0400
> To: <tentec@contesting.com>
>
> Tody,
>
> I concur with Bill's writting's. I didn't have the 1.8kc filter in my 
> Orion,
> so I moved the 1kc filter into the 1.8kc slot, put the 600hz filter 
> into the
> 1kc slot, and left the 500hz and 250hz filters installed and enabled. 
> Really
> sounds quite impressive, especially in this CW contest going on this
> weekend.
>
> The Inrad filter is almost a half an inch taller than the TT filters, 
> but I
> did put the cover back over the filters, but just did not tighten it 
> down
> fully. If I was going to keep my Orion, I would modify the filter 
> cover.
>
> Tom - W4BQF

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec