Hi Ron,
Thanks for your message. I just hope I am not expecting the IF DSP rigs
to do miracles.
In case you had/have a Argo V, do you like the receiver? I had asked the
list a few weeks back about the receivers in the Corsair II (I have one now)
and the Argo V (might get one soon). I wish I had the TS-570DG to compare
side by side with the Corsair II. Alas, the Kenwood has been sold. The
Corsair
seems mighty nice, so far.
Thanks, again to all.
73, Dave NR3E
-----Original Message-----
From: Ron Zond [mailto:k3miy@csonline.net]
Sent: Wednesday, January 28, 2004 11:27 AM
To: tentec@contesting.com
Subject: [TenTec] IF DsP TEn Tec Argo V
Dave
The Argo V does fine copying SSB sigs down to about 1100Hz bandwidth. For
CW, using the DSP filters in concert with Pass Band Tuning gives good
results.
Adjacent signals do not block a weak signal, but using the filters with PBT
will usually work satisfactorily. Good luck with whichever you choose.
Ron
K3MIY
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|