> Bill Tippett <btippett@alum.mit.edu> wrote:
>
> BTW, I went back and looked carefully at the FT-1000MP,
> but I honestly cannot tell if the measurements were at
> 1 or 5 kHz.
The innermost points of the swept graphs has been 1 kHz
as long as I have been doing the testing (since May 1997).
A couple of the very earliest tests used slightly
different frequencies - the innermost points on the `MP
were somewhat oddball - the BDR was about (but not
exactly) 500 Hz spacing and the IMD was 2 kHz spacing.
This is not the case for the Mark V or Field, both of
which I tested.
Contrary to a couple of posts, the points shown are
*never* inside the passband of the filters - just inside
the skirts.
73, Michael, KC1SX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|