Re: [TenTec] Ten-Tec Parts Needed

[aluscre <aluscre@neo.rr.com>]

Kent
Here is how I create these type of adapters. 
http://www.qsl.net/k8zt/adapter.html
I fact I have on that goes fro 4 pin socket to ¼ phone plug to use my 
new Ten-Tec mics on older Ten-Tec equipment and an 8 pin socket to 4 pin 
plug to use my kenwood wired mic with ten-tec equipment.


Kent A. Badger wrote:

> Please check your shack for the following: ---A new front panel for an
> Argosy II          ---T-T model 1126 T/R switch for Argosy II ---T-T
> model 234 Speech Processor           ---Does anyone know where an
> in-line, 4 pin, chassis-type connector with some sort of enclosure can
> be found?......I'm trying to mate the standard T-T 4-pin hand mikes to
> some non T-T equipment and don't wish to butcher up the T-T mike
> connectors......Please email direct with cost including shipping........
> Many thanks for your time........73..........Kent, N3KB   
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>  
--
|--------------------------|
    Anthony A. Luscre    
           K8ZT      
       Stow, Ohio	  
|--------------------------|
   Visit My Website at
 http://www.qsl.net/k8zt
|--------------------------|