When someone hits "Reply All" then you will receive their reply directly AND
you will receive the reply through the reflector. Delete the one you find
the bigger bother.
Regards, Mike N4NT@chartertn.net
----- Original Message -----
From: "William Mansey" <WA2PVK@prodigy.net>
To: <tentec@contesting.com>
Sent: Thursday, July 20, 2000 9:43 PM
Subject: [TenTec] Thanks
|
| Thanks for the suggestions. I will check the baud rate and the wiring.
One
| response mentioned connecting pin 2 to pin 2 and 3 to 3 but this is not
what
| the manual indicates. It indicates that they should be 2 to 3 and 3 to 2.
| There is only one other wire which goes from pin 5 of the db-9 to pin 7 of
| the db-25. There is a jumper between pin 4 and 6 on the db-9 connector.
| The program I am currently trying is called TRX Manager. This works with
my
| Kenwood TS-570DG and a standard db-9 to db-9 cable. I will check the
| settings and try again. The problem is not with the com port so it must
be
| either a wiring problem or a problem with baud rate. I do appreciate the
| responses. I hope to get this working but, even if I am unsuccessful, I
| will continue to enjoy using the Omni the quaint old fashioned way - - -
| with "real" knobs and buttons!!!
| YES - I am also getting multiple messages. Perhaps someone (or
| something) is taking this reflector thing too far! Thanks again; BILL
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|