The solution is to order a PTO rebuild kit from TenTec for about $25
or so and follow the directions that come with it. After you've done
one like this, you're an expert. If you are handy with electronics,
you will have no problem.
Steve N4LQ
----- Original Message -----
From: K & H Darwin <darwin@together.net>
To: TenTec List <tentec@contesting.com>
Sent: Sunday, October 03, 1999 9:07 PM
Subject: [TenTec] Sticky VFO.
>
> My new Omni C has VFO problems. I turn the knob but the VFO doesn't
always
> move. I assume this is that TenTec VFO problem y'all have posted
about so
> often. Until now, I simply ignored all those posts.
>
> So what was the solution again? Rebuild? Regrease? How difficult
is the
> task?
>
> Keith
> KD1E
> Ferrisburg, VT
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|