My new Omni C has VFO problems. I turn the knob but the VFO doesn't always
move. I assume this is that TenTec VFO problem y'all have posted about so
often. Until now, I simply ignored all those posts.
So what was the solution again? Rebuild? Regrease? How difficult is the
task?
Keith
KD1E
Ferrisburg, VT
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|