Karl Heimbach wrote:
>
> Gang,
>
> My Omni VI indicates an SWR of 1.5 when connected to a dummy load. (The
> dummy load and coax are okay and were tested with another transceiver which
> indicated an SWR of 1.0).
>
> On page 4-2, Section 4-3 of the manual, bridge transformer "T1", on the low
> pass filter board is mentioned, but I've been unable to find any SWR
> alignment information.
>
> Can anyone help?
>
> Thanks,
>
> Karl - W5QJ
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
DO NOT touch the swr capacitor on the Low Pass filter board unless you
are ready, willing, and ABLE to perform the complete power/ALC alignment
as
specified on the 9mc filter board.
That swr variable cap is usually set for a minimum
voltage(DCVolts) on 20mtrs at a specific connector
on the 9mc filter board.
If you want specifics email me for the info or call
TTTech support, which is what I did.
Bill Cook N4WC
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|