Gang,
My Omni VI indicates an SWR of 1.5 when connected to a dummy load. (The
dummy load and coax are okay and were tested with another transceiver which
indicated an SWR of 1.0).
On page 4-2, Section 4-3 of the manual, bridge transformer "T1", on the low
pass filter board is mentioned, but I've been unable to find any SWR
alignment information.
Can anyone help?
Thanks,
Karl - W5QJ
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|