A lot of times the noise comes from the controller, not the motor. If you see
increased QRM, ferrites on the AC line to the controller will reduce the hash
going back to the AC line. Also ferrites on the motor leads as well.
the more pricey controllers will have a switching frequency of 3, 6, 8, 12, or
16 KHz. It will be interesting to see what yours turns out to be.
73, Carl N9GC
----- Original Message -----
From: "Robert Chudek - K0RC" <k0rc@citlink.net>
To: "Minnesota Wireless Association" <mwa@w0aa.org>, cq-contest@contesting.com
Sent: Thursday, December 10, 2009 3:18:11 PM GMT -06:00 US/Canada Central
Subject: [MWA] New furnace... off topic, but related to contesting
The serviceman just left after installing a new furnace controller. I am
considering replacing the P.O.S. furnace that has kept the repair department in
an unforecasted revenue stream the last 5 years.
There has been advancements in technology in the past 17 years. This includes a
variable speed DC blower motor upgrade from a multi-speed AC motor. Does anyone
have any experience in the newer technologies in regard to my HF gear?
Specifically, a variable speed DC motor sounds like it might be an RFI
generator.
73 de Bob - KØRC in MN
_______________________________________________
Minnesota Wireless Association mailing list
To post a message: MWA@w0aa.org
List Help: http://mail.w0aa.org/mailman/listinfo/mwa_w0aa.org
MWA Official Web Site: http://www.w0aa.org
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|