Just picked up a 2100B at our local hamfest. Opened the covers to rewire it for
230v and noticed that both of the caps on the 117v input were burnt off. I
looked at the schematic and I see that only in the 100v input configuration are
these caps used but the fellow who owned the amp used it on 117v.
If I wire it for 230v do I need to replace these caps? It is quit likely that
the fellow who owned it , and bought it new from Henry Radio, never had it out
of the cabinet.
Thoughts ?
Jack
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|