At 07:08 PM 3/16/2009, w7upf wrote:
>I had a similar experience with a G-1000SDX and found a slippage problem
>with the rubber drive "belt" inside the controller unit.
My rotator control cables have Cinch plugs at the panel coming into the
shack. I think the older Yaesu control boxes use these on the back of the
box too. I had similar problems which traced back to these plugs - applied
some CAIG Labs ProGold conductivity enhancer to the male prongs, plugged
them in and out a few times, and the problem went away.
73, Pete N4ZR
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|