I still have some old Drake TR7 pre-driver boards, which have around 20 dB
gain up nearly to 6M. They will produce around 1V p-p into 50 ohms, powered
with 12V. Dunno what shipping to NZed would be, but you're welcome to one
for that amount in US funds. Figure 10 oz or so weight, mostly box/packing.
Used some of them as pre-amps for rcvg loops on low h-f cuz they have high
dynamic range and low noise.
73 Dave W8FGX
----- Original Message -----
From: "Ross" <rbiggar@ihug.co.nz>
To: <yaesu@contesting.com>
Sent: Monday, March 16, 2009 11:13 PM
Subject: [Yaesu] Increasing FT1000MP Transverter output
> Thanks to those that replied to my question about the FT1000MP transverter
> output.
> Yes I finally measured it with my power meter and it is a lot lower than I
> expected, from 0 to .1mw max.
>
> I would like to use the FT1000MP as a second rig to drive a transverter
> from 28 to 432mhz,
> unfortunatelt the transverter is designed for inputs between 0 and 20mw.
>
> Can someone guide me to a small commercial RF amplifier that I could use
> to at 28mhz, to boost the FT1000MP output power
> to say 20mw.
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|